Backup Lamp Switch: Service and Repair

Backup Lamp Switch Replacement

Removal Procedure





Remove the backup lamp switch (1).

* Disconnect the wiring harness plug from the backup lamp switch.
* Remove the backup lamp switch.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

Note: Use a new seal ring.

1. Install the backup lamp switch.

* Tighten the backup lamp switch (1).

Tighten to 20 Nm (15 lb ft).

* Connect the wiring harness plug to the backup lamp switch.

2. Inspect the transmission fluid level. Refer to Transmission Fluid Check (Transmission Fluid Check).