Overhead Console Reading Lamp and Bulb Replacement

Overhead Console Reading Lamp and Bulb Replacement

Removal Procedure




1. Remove the panel for the microphone (2) and the panel for the sliding sun roof control unit (3) using a suitable tool (flat-bladed tool).
2. Remove the lens from the interior lamp (1).




3. Remove the front interior lamp holder.

* Remove the 2 bolts (1).
* Remove the holders (4) all around.
* Disconnect the wiring harness holder (2).
* Disconnect the wiring harness plug (3).




4. Remove the ultrasound sensor.

* Disconnect the compact plug (1).
* Disconnect the wiring harness at the compact plug (arrow).
* Remove the panel with the ultrasonic sensors (2).

5. Remove the necessary lamps.
Remove the 2 bulbs.

Installation Procedure

1. Install the necessary lamps.
Install the 2 bulbs.
2. Install the ultrasound sensors.

* Install the panel with the ultrasound sensors.
* Insert the wiring harness in the compact plug and lock.
* Connect in the compact plug.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the front interior lamp holder.

* Connect the wiring harness plug.
* Connect the wiring harness holder.
* Connect the holders all around.

Tighten the 2 screws to 1.5 Nm (13 lb in).

4. Install the lens for the interior lamp.
Install the 4 clips.
5. Install the microphone panel and the panel for the sliding sun roof control unit.
Install the 2 panels.