Headlamp Alignment Control Module: Service and Repair

Headlamp Leveling Control Module Replacement

Removal Procedure

Warning: Refer to Battery Disconnect Warning (Service Precautions).


Note: When replacing the headlamp leveling module, before removing the control unit, carry out a "Reset" using TECH 2. For reprogramming procedures, refer to Control Module References (Programming and Relearning).

1. Disconnect the battery.
2. Remove the drivers knee bolster. Refer to Driver Knee Bolster Replacement (Service and Repair).




3. Remove the headlamp leveling module.

* Remove the bolt (1).
* Remove the headlamp leveling module.
* Disconnect the wiring harness plug (2).

Installation Procedure

Caution: Refer to Fastener Caution (Fastener Caution).

1. Position the headlamp leveling module.

* Connect the wiring harness plug.
* Install the headlamp leveling module.

- Tighten the bolt to 2.5 Nm (22 lb in).
- Tighten the nut to 2.5 Nm (22 lb in).

2. Install the drivers knee bolster. Refer to Driver Knee Bolster Replacement (Service and Repair).
3. Connect the battery.
4. For reprogramming procedures, refer to Control Module References (Programming and Relearning).