Headlamp Replacement (with Dipped Beam)

Headlamp Replacement (with Dipped Beam)

Removal Procedure

Warning

The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system.

Warning

The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:

* Never open the high intensity discharge system ballast or the arc tube assembly starter.
* Never probe between the high intensity discharge system ballast output connector and the arc tube assembly.

Warning: Refer to Halogen Bulb Warning (Service Precautions).


Note: Warning, high voltage. Do not touch components in the xenon dipped beam when the dipped beam is switched on. Ignition and light switch OFF.

1. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Front Bumper Fascia Replacement).
2. Remove the fuse.




3. Release the headlamp.
Remove the 3 screws (1, 2).
4. Remove the headlamps.

* Remove the connector.
* Remove the headlamps.
* Disconnect the wiring harness plug (3).

5. Remove the lights and the control units.

Installation Procedure

1. Install the lights and control units.
2. Insert the headlamp.

* Connect the wiring harness plug.
* Install the connector.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the headlamp.
Install the connector.

Tighten the 3 bolts to 2.5 Nm (22 lb in).

4. Insert the fuse.
5. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (Front Bumper Fascia Replacement).
6. Adjust the headlamp.