Automatic Transmission Range Selector Lever Replacement

Automatic Transmission Range Selector Lever Replacement

Removal Procedure

1. Remove the front floor console. Refer to Front Floor Console Replacement (Service and Repair).




2. Remove the range selector cable (2) from the selector lever.

* Remove the retaining clamp (1).
* Disconnect the selector lever cable from the bracket.




3. Remove the range selector lever assembly.

* Disconnect the wiring harness plug (1).
* Remove the 4 bolts (2).
* Remove the selector lever assembly.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the selector lever assembly.

* Insert the range selector lever assembly.

Tighten the 4 bolts to 5 Nm (44 lb in).

* Connect the wiring harness plug (1).




2. Install the selector cable (2) to the selector lever.

* Install the selector lever cable to the bracket.
* Install the retaining clamp.

3. Install the front floor console. Refer to Front Floor Console Replacement (Service and Repair).
4. For programming procedures, refer to Control Module References (Programming and Relearning).