Rear Object Alarm Module Replacement (PAS)

Rear Object Alarm Module Replacement (PAS)

Removal Procedure

1. When replacing the control unit, before removing the control unit, carry out a "Reset" using the Tech 2. For reprogramming procedures, refer to Control Module References (Programming and Relearning).
2. Disconnect the battery.
3. Open the service flap.




4. Disconnect the wiring harness plug for the rear electronics module (REC).

* Disconnect the 6 wiring harness plugs (1).
* Unlock and detach.

5. Release the rear electronics module (REC).
Remove the nut (arrow).
6. Remove the REC.
Release the object alarm module.
7. Remove the object alarm module (2).

* Disconnect the 2 wiring harness plugs.
* Remove the object alarm module.

Installation Procedure

1. Install the object alarm module.

* Insert the object alarm module.
* Connect the 2 wiring harness plugs.

2. Insert the REC.
Install the object alarm module.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Connect the REC.

Tighten the nut to 7 Nm (62 lb in).

4. Connect the wiring harness plug for the rear electronics module (REC).
Connect the 6 wiring harness plugs.
5. Close the service flap.
6. Connect the battery.
7. For reprogramming procedures, refer to Control Module References (Programming and Relearning).