Inflatable Restraint Roof Side Rail Module Replacement (Sedan Replacement)

Roof Side Rail Inflatable Restraint Module Replacement (Sedan Replacement)

Removal Procedure

Warning: Refer to SIR Inflator Module Handling and Storage Warning (SIR Inflator Module Handling and Storage Warning).


Warning

In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

1. Remove the headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair).





Note: With already replaced roof side rail modules, do not bend the clamps on positions 3 and 4.

2. Remove the roof side rail modules.

* Release and disconnect the wiring harness plug.
* Remove the 2 bolts (1).
* Remove the 6 screws (2).

Installation Procedure

Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the roof side rail modules.
Connect and latch the wiring harness plug.

Tighten the 8 screws to 1.5 Nm (13 lb in).

2. Install the headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair)

Note: After ignition ON, the roof side rail module system readiness indicator illuminates for 4 seconds and then goes out.

3. Readiness indicator.