Inflatable Restraint Steering Wheel Module Replacement

Steering Wheel Inflatable Restraint Module Replacement

Removal Procedure

Warning: Refer to SIR Inflator Module Handling and Storage Warning (SIR Inflator Module Handling and Storage Warning).

Warning: Refer to Battery Disconnect Warning (Service Precautions).

1. Disconnect the battery.
2. Wait 1 minute for airbag to deactivate.





Note: Ensure that the retaining wire is not bent.

3. Remove the airbag.

* Turn the steering wheel 90 degrees (I).
* Push the retaining wire in the direction of the steering column using a small screwdriver in the service opening (II) and remove the airbag module.
* Release and disconnect the wiring harness plug.

Installation Procedure

1. Install the airbag.

* Connect and latch the wiring harness plug.
* Install the 2 clips.

2. Perform a readiness inspection.
3. Connect the battery.
4. For programming procedures, refer to Control Module References (Programming and Relearning).