Inflatable Restraint Front End Sensor Replacement

Inflatable Restraint Front End Sensor Replacement

Removal Procedure

Warning: Refer to Battery Disconnect Warning (Service Precautions).

1. Disconnect the battery.
2. Wait 1 minute for the airbag to deactivate.
3. Remove the upper radiator grille. Refer to Front Bumper Upper Fascia Grille Replacement (Front Bumper Upper Fascia Grille Replacement).




4. Remove the airbag sensor.

* Loosen the 2 bolts (1).
* Remove the airbag sensor from the guide.
* Disconnect the wiring harness plug (2).

Installation Procedure

1. Install the airbag sensor.

* Connect the wiring harness plug.

Caution: Refer to Fastener Caution (Fastener Caution).

* Insert the airbag sensor in the guide.

Tighten the 2 bolts to 6 Nm (53 lb in).

2. Install the upper radiator grille. Refer to Front Bumper Upper Fascia Grille Replacement (Front Bumper Upper Fascia Grille Replacement).
3. Connect the battery.
4. For programming procedures, refer to Control Module References (Programming and Relearning).