Rack and Pinion Inner Tie Rod Replacement

Rack and Pinion Inner Tie Rod Replacement

Removal Procedure




1. Remove the corresponding outer tie rod end from the tie rod. Refer to Steering Linkage Outer Tie Rod Replacement (Steering Linkage Outer Tie Rod Replacement).

Note: To remove and refit the right-hand tie rod the left-hand boot must also be detached from the steering gear. A flat surface is to be found on the steering shaft side to hold against the steering rack (arrows).

2. Remove the corresponding boot. Refer to Rack and Pinion Boot Replacement (Service and Repair).
3. Remove the inner tie rod from the steering rack.
Counterhold with an open-ended wrench (2) on the toothed rack flat.

Installation Procedure

Caution: Refer to Fastener Caution (Fastener Caution).




1. Install the tie rod inner linkage to the steering gear.

Tighten to 90 Nm (67 lb ft).

* Clean the rack thread and coat with locking compound.
* Install the inner tie rod to the rack.
Counterhold with an open-ended wrench (2) on the toothed rack flat (arrow).

2. Install the boot or boots. Refer to Rack and Pinion Boot Replacement (Service and Repair).
3. Install the corresponding outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement (Steering Linkage Outer Tie Rod Replacement).
4. Check the straight-ahead position, adjust if necessary. Refer to Straight Ahead Inspection (Removal and Replacement).
5. Check the toe-in, adjust if necessary. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment (Service and Repair).