Park/Neutral Position Switch Installation

Park/Neutral Position Switch Installation

Special Tools

J 45404 - Transmission Indicator Alignment Tool

For equivalent regional tools, refer to Special Tools (Tools and Equipment).




1. Install the park/neutral position switch (72) to the manual valve lever shaft.
2. Temporarily tighten the 2 park/neutral position switch bolts (71).





Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the manual shift shaft retaining nut lock washer (70) and manual shift shaft retaining nut (69). Tighten the nut to 6.9 Nm (61 lb in).




4. Place the manual shift detent lever assembly in the Neutral (N) position.
5. Install the J 45404 - indicator alignment tool to the manual shift detent lever assembly.
6. Rotate the park/neutral position switch until the neutral base line on the switch assembly lines up with the indicator line on J 45404 - indicator alignment tool.
7. Tighten the 2 park/neutral position switch bolts (71). Tighten the bolts to 25 Nm (18 lb ft).
8. Remove J 45404 - indicator alignment tool from the manual shift detent lever assembly.




9. If no special tool available, align the groove and neutral basic line. Lock the park/neutral position switch with the 2 park/neutral position switch bolts (71). Tighten the bolts to 25 Nm (18 lb ft).




10. Bend the tabs on the manual shift shaft retaining nut lock washer (70) with a screwdriver.