Operation CHARM: Car repair manuals for everyone.

P0A1E




DTC P0A1E

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC P0A1E
- Starter/Generator Control Module Internal Performance

Circuit/System Description

The internal fault detection is handled inside the starter/generator control module (SGCM). No external circuits are involved.

Conditions for Running the DTC

Engine ON.

Conditions for Setting the DTC

The SGCM detects an internal ECU malfunction.

Action Taken When the DTC Sets

Hybrid system disabled.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* The ignition must be cycled before the DTC can be cleared.

Reference Information
Schematic Reference

Hybrid Controls Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Starter/Generator Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Replace the SGCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for SGCM replacement, setup, and programming