Automatic Day-Night Mirrors Inoperative
Automatic Day-Night Mirrors Inoperative
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The automatic day-night rearview mirror uses 2 photocell sensors that detects an increase in light. One sensor is located in the rear side of the mirror. This sensor determines the light condition present at the mirror face. The other sensor is the ambient light sensor, located on the front of the mirror or windshield side. This sensor determines the amount of light present at the mirror. When the ambient light sensor senses a low light condition and a high light condition from behind at the headlight sensor, the inside rearview mirror will automatically darken the face of the mirror.
Reference Information
Schematic Reference
Inside Rearview Mirror Schematics (Inside Rearview Mirror Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Automatic Day-Night Mirror Description and Operation (Automatic Day-Night Mirror Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition ON, headlamps ON, vehicle in PARK, cover the front light sensor with a towel or other suitable item. Shine a flashlight at the rear light sensor while observing the inside rearview mirror face. The inside rearview mirror face should dim.
2. Park brake applied, place the transmission in REVERSE. The inside rearview mirror face should transition from dim to bright.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the inside rearview mirror.
2. Test for less than 10 ohms between the low reference circuit terminal 8 and ground.
• If greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 13 and ground.
• If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
4. Ignition ON, park brake applied, vehicle in REVERSE, verify that a test lamp illuminates between the backup lamp control circuit terminal 9 and ground.
• If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, refer to Backup Lamps Malfunction (Backup Lamps Malfunction).
5. If all circuits test normal, test or replace the inside rearview mirror.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Inside Rearview Mirror Replacement (Inside Rearview Mirror Replacement)