Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Replacement

Removal Procedure




1. Remove the starter. Refer to Starter Motor Replacement (LAT) (Service and Repair)Starter Motor Replacement (LY7) (Service and Repair)Starter Motor Replacement (LE5) (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.




3. Remove the CKP sensor bolt.
4. Remove the CKP sensor.

Installation Procedure




1. Lubricate the CKP sensor O-ring seal with clean engine oil.
2. Install the CKP sensor.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CKP sensor bolt and tighten to 10 Nm (89 lb in).




4. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
5. Install the starter. Refer to Starter Motor Replacement (LAT) (Service and Repair)Starter Motor Replacement (LY7) (Service and Repair)Starter Motor Replacement (LE5) (Service and Repair).
6. Perform the crankshaft position system variation learn procedure. Refer to Crankshaft Position System Variation Learn (Service and Repair).