Inflatable Restraint Front End Sensor Replacement

Inflatable Restraint Front End Sensor Replacement

Removal Procedure

1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).
2. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement (Air Cleaner Inlet Duct Replacement).




3. Remove the connector position assurance (CPA) from the electrical connector on the front end sensor.
4. Disconnect the front end sensor electrical connector from the front end sensor.
5. Remove the 2 integral bolts that retain the front end sensor to the frame front crossmember.
6. Remove the front end sensor from the vehicle.

Installation Procedure




1. Install the front end sensor to the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the 2 integral bolts that retain the front end sensor to the frame front crossmember and tighten to 8 Nm (71 lb in).
3. Connect the sensor electrical connector to the front end sensor.
4. Install the CPA to the sensor electrical connector.
5. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement (Air Cleaner Inlet Duct Replacement).
6. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).