Rear

REAR AXLE HUB & BEARING ASSEMBLY LH
REPLACEMENT
1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
3. SEPARATE SKID CONTROL SENSOR WIRE
a. Disconnect the skid control sensor connector.





4. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH
a. Remove the 4 bolts and the hub & bearing assembly LH.





5. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
a. Install the hub & bearing assembly LH with the 4 bolts.
Torque: 63 Nm (642 kgf-cm, 46 ft. lbs.)
6. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the skid control sensor connector.

NOTICE: Do not twist the sensor wire when connecting it.

7. INSPECT REAR AXLE DEVIATION AND BACKLASH
8. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
9. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
10. CHECK ABS SPEED SENSOR SIGNAL