Rear Wiper Rubber

REAR WIPER RUBBER

REPLACEMENT
1. REMOVE REAR WIPER RUBBER




a. Raise the rear wiper blade to the position as shown in the illustration so that the meshing of the claw can be disengaged with a clicking sound.

NOTE: Be careful not to break the claw.

b. Pull the rear wiper blade straight from the wiper arm toward the left side of the vehicle.

NOTE: Do not fold the rear wiper arm without the rear wiper blade.




c. Pull the end of the rubber protruded from the blade stopper as shown in the illustration.

NOTE: Do not forcibly pull out the wiper rubber. Otherwise, the backing plates will be deformed or the blade claw will be damaged.

HINT: Pushing the position close to the middle of the blade raises the rubber, which makes it easier to pull the rubber out.

2. INSTALL REAR WIPER RUBBER




a. Install the 2 wiper rubber backing plates to the rear wiper rubber.

NOTE: Be sure to install the wiper rubber backing plates in the right direction.




b. Insert the rear wiper rubber from the claw side of the middle of the rear wiper blade the end position.




c. After passing the rear wiper rubber through the rear end side claw, extend it from the rear end stopper and pass it through the front tip side claw.