Pinout Values and Diagnostic Parameters

ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: TERMINALS OF ECU

TERMINALS OF ECU

1. CHECK TRANSPONDER KEY AMPLIFIER





(a) Disconnect the T7 amplifier connector.
(b) Measure the resistance of the wire harness side connector.





- If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the T7 amplifier connector.
(d) Measure the resistance and voltage of the connector.





- If the result is not as specified, the amplifier may have a malfunction.

(e) Inspect using an oscilloscope.





(1) Waveform 1 (Reference)










(2) Waveform 2 (Reference)






2. CHECK TRANSPONDER KEY ECU ASSEMBLY





(a) Disconnect the T8 ECU connector.
(b) Measure the voltage and resistance of the wire harness side connector.





- If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the T8 ECU connector.
(d) Measure the voltage of the connector.





HINT: *1: w/ Cruise Control
- If the result is not as specified, the ECU may have a malfunction.

(e) Inspect using an oscilloscope.





(1) Waveform 1 (Reference)










(2) Waveform 2 (Reference)










(3) Waveform 3 (Reference)










(4) Waveform 4 (Reference)






3. CHECK ECM





(a) Measure the voltage and resistance of the connectors.





- If the result is not as specified, the ECM may have a malfunction.

(b) Inspect using an oscilloscope.





(1) Waveform 1 (Reference)










(2) Waveform 2 (Reference)