Disassembly

MIRROR: OUTER REAR VIEW MIRROR: DISASSEMBLY

DISASSEMBLY
CAUTION: If the mirror shatters during removal, flying debris may cause injuries. Be sure to wear protective clothing, gloves, glasses, etc. when performing these procedures.
NOTE: When replacing the mirror body, prevent damage to the mirror body by placing a protective cloth on the work area.

1. DISCONNECT MIRROR






(a) Face the mirror holder upward and look at the bottom of the mirror. Find the 2 grooves between the mirror holder and holder base. Insert a screwdriver into a groove and twist it to release the claw. Then repeat for the other groove.
HINT: Tape the screwdriver tip before use.
CAUTION: To prevent the mirror from shattering and causing flying debris, apply tape to the front of the mirror.
NOTE: To prevent damage to the vehicle, apply protective tape on the mirror holder base near the lower edge of the mirror. A piece of cloth can also be used.

(b) Lift up the lower part of the mirror holder and then release the 2 hooks on the top of the mirror.
(c) Remove the mirror holder.






2. REMOVE MIRROR GARNISH
(a) Detach the 7 claws.
(b) Remove the garnish.
3. REMOVE SIDE TURN SIGNAL LIGHT LENS LH
(a) Disconnect the connector.






(b) Remove the 2 screws and lens.