Reassembly

MIRROR: OUTER REAR VIEW MIRROR: REASSEMBLY

REASSEMBLY





1. INSTALL SIDE TURN SIGNAL LIGHT LENS LH
(a) First set the lens position by inserting the lens peg to the location labeled A in the illustration. Then insert the lens guide to the V-shaped groove as shown in C in the illustration.
(b) Install the lens with the 2 screws labeled B.
(c) Connect the connector.
2. INSTALL MIRROR GARNISH






3. CONNECT MIRROR
HINT: Before connecting the mirror holder, use a dryer to sufficiently heat the backside of the mirror holder where the claws are located.
NOTE: If the ambient temperature is low and the claws are not heated before installing, the claws may be broken.