Installation

2AZ-FE LUBRICATION: OIL PUMP: INSTALLATION

INSTALLATION

1. INSTALL OIL PUMP ASSEMBLY






(a) Install a new gasket and the oil pump with the 3 bolts.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
2. INSTALL OIL PUMP DRIVE GEAR
3. INSTALL NO. 2 CHAIN SUB-ASSEMBLY Installation

4. INSTALL CRANKSHAFT TIMING SPROCKET
5. INSTALL NO. 1 CHAIN VIBRATION DAMPER Installation

6. INSTALL CHAIN SUB-ASSEMBLY Installation

7. INSTALL CHAIN TENSIONER SLIPPER Installation

8. INSTALL TIMING CHAIN GUIDE Installation

9. INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE Installation

10. INSTALL TIMING CHAIN COVER OIL SEAL Replacement

11. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY Installation

12. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY Installation

13. INSTALL CRANKSHAFT PULLEY Installation

14. INSTALL CAMSHAFT TIMING GEAR ASSEMBLY Installation

15. INSTALL OIL PAN SUB-ASSEMBLY Installation

16. INSTALL CRANKSHAFT POSITION SENSOR Installation

17. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY Installation

18. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY Installation

19. INSTALL IGNITION COIL ASSEMBLY Installation

20. INSTALL ENGINE MOUNTING INSULATOR RH Installation

21. INSTALL VANE PUMP ASSEMBLY
22. INSTALL GENERATOR ASSEMBLY Installation

23. INSTALL FAN AND GENERATOR V BELT Installation

24. INSTALL EXHAUST PIPE ASSEMBLY Installation

25. ADD ENGINE OIL Replacement

26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
27. CHECK FOR ENGINE OIL LEAKS
28. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation

29. INSTALL FRONT FENDER APRON SEAL RH Installation

30. INSTALL ENGINE UNDER COVER LH
31. INSTALL ENGINE UNDER COVER RH
32. INSTALL FRONT WHEEL RH Installation

33. INSTALL HOOD SUB-ASSEMBLY Adjustments

34. PERFORM INITIALIZATION
Perform initialization Testing and Inspection.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.