Installation

SUPPLEMENTAL RESTRAINT SYSTEM: STEERING PAD: INSTALLATION

INSTALLATION





1. INSTALL STEERING PAD ASSEMBLY
(a) Check that the ignition switch is in the OFF position.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Work must be started at least 90 seconds after the engine switch is turned off and after the cable is disconnected from the negative (-) battery terminal.

(c) Support the steering pad with one hand.
(d) Connect the 2 airbag connectors to the steering pad.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

(e) Connect the horn connector to the steering pad.
(f) Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
(g) Using a "TORX" socket (T30), tighten the 2 "TORX" screws.
Torque: 8.8 Nm (90 kgf-cm, 78 in-lbf)
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. PERFORM INITIALIZATION
(a) Perform initialization Testing and Inspection.
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.

4. INSPECT STEERING PAD ASSEMBLY
(a) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
(b) Make sure that the horn sounds.
HINT: If the horn does not sound, inspect the horn system Symptom Related Diagnostic Procedures.

5. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.