Installation

SUSPENSION: REAR LOWER CONTROL ARM: INSTALLATION

INSTALLATION

1. INSTALL LOWER CONTROL ARM ASSEMBLY





(a) Install the lower control arm to the rear suspension member, and temporarily tighten the bolt.






(b) Install the nut.
Torque: 105 Nm (1,050 kgf-cm, 77 ft-lbf)
(c) Install the clip.
NOTICE:
- When the holes for the clip are not aligned, adjust them by tightening the nut. The tightening angle for the adjustment must be less than 60°.
- Insert the clip from the rear side of the vehicle.

2. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
3. STABILIZE SUSPENSION Installation







4. FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY
(a) Fully tighten the bolt.
Torque: 115 Nm (1,170 kgf-cm, 85 ft-lbf)
5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a) Inspect and adjust the rear wheel alignment Rear Wheel Alignment.