Removal

SUSPENSION: REAR NO. 1 SUSPENSION ARM: REMOVAL

REMOVAL

1. REMOVE REAR WHEEL

2. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Remove the 2 bolts and disconnect the No. 3 parking brake cable.

3. DISCONNECT SKID CONTROL SENSOR WIRE
(a) Disconnect the skid control sensor connector.
(b) Remove the bolt and disconnect the wire.

4. DISCONNECT REAR STABILIZER LINK ASSEMBLY
(a) Remove the nut, and disconnect the stabilizer link LH.
HINT: If the ball joint turns together with the nut, use a 5mm hexagon wrench to hold the stud.

5. REMOVE LOWER CONTROL ARM ASSEMBLY

(a) Support the No. 1 suspension arm LH.

(b) Remove the bolt and disconnect the member side lower control arm LH from the rear suspension member.

(d) Using SST, remove the lower control arm LH from the axle carrier LH.
SST: 09610-20012
NOTE: Do not damage the dust cover.

6. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY
(a) Remove the disc brake caliper Disassembly.
7. REMOVE REAR DISC Removal

8. REMOVE REAR SUSPENSION NO. 1 ARM ASSEMBLY

(a) Remove the clip and nut.

(b) Using SST, disconnect the axle carrier LH front side from the No. 1 suspension arm LH.
SST: 09628-62011

NOTE:
- Do not damage the dust cover.
- Hang the upper control arm on the axle carrier LH side with a wire or equivalent.

(c) Remove the bolt and nut, and disconnect the axle carrier LH side from the suspension No. 1 arm LH.
NOTE: When removing the bolt, hold the nut in place.

(d) Remove the bolt and nut, and disconnect the shock absorber with coil spring.
NOTE: When removing the bolt, hold the nut in place.

(e) Remove the bolt and nut, and disconnect the rear side suspension No. 1 arm LH.
NOTE: When removing the bolt, hold the nut in place.

(f) Remove the 3 bolts and suspension No. 1 arm LH.

(g) Remove the nut, suspension arm bracket LH and suspension support stopper.