Installation

2AZ-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

INSTALLATION





1. INSTALL KNOCK SENSOR
(a) Install the knock sensor with the nut.
Torque: 20 Nm (205 kgf-cm, 15 ft-lbf)
(b) Connect the sensor connector.






2. INSTALL NO. 1 INTAKE MANIFOLD INSULATOR
(a) Install the No. 1 intake manifold insulator.
3. INSTALL INTAKE MANIFOLD





(a) Install a new gasket into the intake manifold.






(b) Install the intake manifold with the 5 bolts and 2 nuts.
Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)
(c) Install the wire harness clamp onto the intake manifold.






(d) Connect the union to check valve hose.






(e) Connect the ventilation hose.
4. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY WITH FUEL TUBE SUB-ASSEMBLY Installation

5. CONNECT FUEL TUBE SUB-ASSEMBLY Installation

6. INSTALL THROTTLE BODY ASSEMBLY Installation

7. INSTALL OUTER COWL TOP PANEL Installation

8. INSTALL FRONT WIPER MOTOR AND LINK

9. INSTALL COWL TOP VENTILATOR LOUVER LH

10. INSTALL COWL TOP VENTILATOR LOUVER RH

11. INSTALL HOOD TO COWL TOP SEAL

12. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

14. INSTALL WINDSHIELD WIPER ARM COVER

15. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE Installation

16. ADD ENGINE COOLANT Service and Repair

17. INSPECT FOR COOLANT LEAK Testing and Inspection

18. INSPECT FOR FUEL LEAK Vehicle Damage Warnings
19. INSTALL NO. 1 ENGINE COVER Installation