Rear Axle Hub

AXLE: REAR AXLE HUB: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY Removal

3. INSPECT REAR AXLE HUB BEARING





(a) Inspect the axle hub and bearing backlash.
(1) Using a dial indicator, check the backlash near the center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
If the backlash exceeds the maximum, replace the axle hub and bearing.






(b) Inspect the axle hub and bearing runout.
(1) Using a dial indicator, check the runout of the surface of the axle hub.
Maximum:
0.07 mm (0.0028 in.)
If the runout exceeds the maximum, replace the axle hub and bearing.
4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE Installation

6. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)