Installation

MIRROR (EXT): OUTER REAR VIEW MIRROR: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

(a) Temporarily install the outer rear view mirror to the front door panel with the 3 screws.

NOTICE:
* When reusing the outer rear view mirror, be sure to temporarily install the screws by hand so that the threads of the mirror are threaded correctly.

(b) Tighten the 3 screws.

Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
* As the threads of the mirror may become stripped, causing the mirror to fall off, do not tighten the screws with more than the specified torque.
* When retightening the screws, do not retighten a screw more than 2 times. However, if the screw is being installed in the same location it was removed from, it is acceptable to retighten it 3 times.

(c) Connect the connector.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH Reassembly

3. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Reassembly

4. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Reassembly

5. INSTALL DOOR ASSIST GRIP COVER LH Reassembly

6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH Reassembly

7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH Reassembly