Disassembly

BRAKE (REAR): REAR BRAKE: DISASSEMBLY

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. REMOVE REAR DISC BRAKE PISTON

(a) Using SST, remove the piston by turning it counterclockwise.





SST : 09719-12010

09719-01030

NOTICE:
* Do not damage the piston.
* Do not spatter the brake fluid.

2. REMOVE CYLINDER BOOT

(a) Remove the cylinder boot from the rear disc brake piston.

3. REMOVE PISTON SEAL

(a) Using a screwdriver, pry out the piston seal from the rear disc brake cylinder.

Text in Illustration









HINT
Tape the screwdriver tip before use.

NOTICE:
Do not damage the inner surface or piston seal groove of the cylinder.

4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

5. REMOVE REAR DISC BRAKE BLEEDER PLUG