Installation

2AR-FE ENGINE MECHANICAL: ENGINE UNIT: INSTALLATION

1. INSTALL IGNITION COIL ASSEMBLY Installation

2. INSTALL ENGINE COOLANT TEMPERATURE SENSOR Installation

3. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY Installation

4. INSTALL WATER BY-PASS HOSE

(a) Install the No. 1 and No. 2 water by-pass hoses.

5. INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET

(a) Install the bracket with the 4 bolts.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

6. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY Installation

7. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR Installation

8. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Installation

9. INSTALL NO. 2 MANIFOLD STAY Installation

10. INSTALL MANIFOLD STAY Installation

11. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

(a) Apply a light coat of engine oil to a new O-ring.

(b) Install the O-ring to the dipstick guide.

(c) Install the dipstick guide with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Install the engine oil dipstick.

12. INSTALL INTAKE MANIFOLD Installation

13. CONNECT NO. 2 PCV HOSE Installation

14. CONNECT WIRE HARNESS Installation

15. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY Installation

16. CONNECT WIRE HARNESS Installation

17. CONNECT FUEL TUBE SUB-ASSEMBLY Installation

18. INSTALL THROTTLE BODY ASSEMBLY Installation