Installation
INTERIOR PANELS / TRIM: UPPER INSTRUMENT PANEL: INSTALLATION
HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.
1. INSTALL GLOVE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY
(a) Insert the bottom side of the glove compartment door lock cylinder as shown in the illustration, hold down the stopper and install the glove compartment door lock cylinder.
2. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(a) Attach the 4 clips, 3 claws and 5 guides to install the upper instrument panel.
(b) Connect the connectors and attach the clamp.
(c) Install the 2 passenger airbag bolts [C].
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
(d) Install the screw [A] and 2 bolts [B].
Text in Illustration
3. INSTALL FRONT PILLAR GARNISH LH Installation
4. INSTALL FRONT PILLAR GARNISH RH Installation
5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
(a) Install the front door opening trim weatherstrip.
6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
(a) Install the front door opening trim weatherstrip.
7. INSTALL LOWER INSTRUMENT COVER RH
(a) Attach the 5 claws to install the lower instrument cover.
8. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
(a) Attach the 2 guides to install the glove compartment door.
(b) Attach the 2 stoppers.
Text in Illustration
9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
(a) Attach the 4 clips to install the No. 2 instrument cluster finish panel garnish.
10. INSTALL COMBINATION METER ASSEMBLY Installation
11. INSTALL METER HOOD SUB-ASSEMBLY
(a) Attach the 8 claws to install the meter hood.
12. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
(a) Connect the connector.
(b) Attach the 5 clips and guide to install the center instrument cluster finish panel.
13. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
(a) Connect each connector.
(b) Attach the 2 clips, 3 claws and guide to install the No. 1 instrument cluster finish panel garnish.
14. INSTALL STEERING WHEEL ASSEMBLY
Installation
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
16. CHECK SRS WARNING LIGHT
Diagnosis System