Rear Axle Hub

AXLE AND DIFFERENTIAL: REAR AXLE HUB: ON-VEHICLE INSPECTION

1. REMOVE REAR WHEEL

2. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

Removal

3. LOOSEN PARKING BRAKE CABLE Removal

4. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY Removal

5. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY Removal

6. REMOVE REAR DISC Removal

7. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, check for looseness near the center of the axle hub.

Maximum:

0.05 mm (0.00197 in.)

NOTICE:
Make sure that the dial indicator is set perpendicular to the measurement surface.

HINT
If the looseness is more than the maximum, replace the axle hub assembly.





8. INSTALL REAR DISC Installation

9. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY Installation

10. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY Installation

11. INSTALL PARKING BRAKE LEVER PROTECTOR

12. INSPECT AND ADJUST PARKING BRAKE

Adjustments

13. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

Installation