Crankshaft Main Bearing

CRANKSHAFT

The cap bolts are tightened in 3 progressive steps.






Step 1:

Using several steps, install and uniformly tighten the 10 bearing cap bolts in the sequence shown in the illustration.

Torque 20 Nm (204 kgf-cm, 15 ft-lbf)

Step 2:

Tighten the 10 bearing cap bolts again in the sequence shown in the illustration.

Torque 40 Nm (408 kgf-cm, 30 ft-lbf)

If a crankshaft bearing cap bolt does not meet the specified torque, replace it.
Mark the front side of each crankshaft bearing cap bolt with paint.

Step 3:

Tighten the 10 bearing cap bolts 90° in the order shown in step 1.
Check that the paint marks are now at a 90° angle to the front.


MAIN BEARING CLEARANCE STANDARD AND LIMIT









MAIN BEARING SIZE CODES

There are 4 sizes of standard bearings, marked "1", "2", "3" and "4" accordingly.






Text in Illustration






EXAMPLE:
Cylinder block (A) "3" + Crankshaft (B) "4" = Total "7"
Select the bearing marked "3".

Bearing Chart:






Standard Cylinder Block Journal Inside Diameter (A):






Standard Crankshaft Main Journal Diameter (B):






Standard Bearing Center Wall Thickness: