Power Steering System

POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: PRECAUTION

1. EXPRESSIONS OF IGNITION SWITCH

HINT
The type of ignition switch used on this model differs according to the specifications of the vehicle.

The expressions listed in the table below are used in this section.





2. PRECAUTION FOR DISCONNECTING BATTERY CABLE

NOTICE:
When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM

(a) The vehicle is equipped with a Supplemental Restraint System (SRS). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident.

Before servicing (including inspection, replacement, removal and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System Service Precautions.

4. PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF ELECTRONIC POWER STEERING COMPONENTS

(a) After replacing the power steering ECU assembly, clear the rotation angle sensor calibration value, initialize the rotation angle sensor and calibrate the torque sensor zero point Programming and Relearning.

5. HANDLING PRECAUTION

(a) When handling the electronic parts:

* Do not subject electronic parts such as ECUs and relays to shocks. Replace parts with new ones if dropped or subjected to a severe blow.

* Do not expose any electronic parts to high temperatures or humidity.

* In order to prevent deformation or malfunctions due to static electricity, do not touch the connector terminals.

(b) Before disconnecting the connectors related to the electronic power steering system, turn the ignition switch to ON, center the steering wheel, and then turn the ignition switch off.

6. PRECAUTIONS FOR CAN COMMUNICATION

(a) CAN communication lines are used to receive information from the skid control ECU and ECM, and to transmit warnings to the combination meter.

When there are any problems in the CAN communication lines, DTCs of the CAN communication line are stored.

(b) Perform troubleshooting for the communication line problems when CAN communication DTCs are stored. Be sure to start troubleshooting of the power steering system after confirming that the CAN communication system is normal.

(c) Since the CAN communication line has a certain length and route, it cannot be repaired temporarily with a bypass wire, etc.