Installation
STEERING COLUMN: STEERING COLUMN ASSEMBLY: INSTALLATION
1. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Align the matchmarks on the No. 2 steering intermediate shaft assembly and steering column assembly.
(b) Install the bolt.
Torque : 35 Nm (357 kgf-cm, 26 ft-lbf)
2. INSTALL STEERING COLUMN ASSEMBLY
(a) Check that the 2 bushings are securely installed to the steering column assembly.
Text in Illustration
HINT
If the bushings are missing or damaged, replace the steering column assembly with a new one.
(b) Install the steering column assembly with the bolt and 2 nuts.
Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)
NOTICE:
* Do not damage the 2 bushings.
* Do not line-up the bolt holes by prying on the collar or bushings. Do not install the bolt at an angle or apply any force to the bushings.
(c) Attach the wire harness clamps to the steering column assembly.
(d) Connect the connectors and attach the wire harness clamps to the power steering ECU assembly.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Align the matchmarks on the No. 2 steering intermediate shaft assembly and steering intermediate shaft assembly.
(b) Install the bolt.
Torque : 35 Nm (357 kgf-cm, 26 ft-lbf)
5. INSTALL STOP LIGHT SWITCH ASSEMBLY Installation
6. INSTALL BRAKE PEDAL RETURN SPRING
(a) Install the return spring.
7. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation
8. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
Installation
9. INSTALL COLUMN HOLE COVER SILENCER SHEET
(a) Install the column hole cover silencer sheet with the 2 clips.
(b) Install the floor carpet.
10. INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
(a) Using pliers, pinch the clamp and attach the claw to install the combination switch assembly with spiral cable sub-assembly to the steering column assembly.
(b) Connect the connectors to the combination switch assembly with spiral cable sub-assembly.
11. INSTALL STEERING COLUMN COVER
NOTICE:
If the steering column cover is installed incorrectly, it will not be possible to assemble the steering column cover.
(a) Attach the claw and 2 pins to install the upper steering column cover.
(b) Attach the 2 claws to install the lower steering column cover.
(c) Attach the 4 claws.
(d) Attach the claw.
HINT
Press the area around the claw to attach it.
12. ADJUST SPIRAL CABLE Installation
13. INSTALL STEERING WHEEL ASSEMBLY
Installation
14. INSPECT STEERING WHEEL CENTER POINT
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
16. INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
Programming and Relearning
17. INSPECT SRS WARNING LIGHT
Diagnosis System