Installation

REAR SUSPENSION: REAR STABILIZER BAR: INSTALLATION

1. INSTALL REAR STABILIZER BUSH





(a) Install the 2 rear stabilizer bushes to the rear stabilizer bar on the outside of the bush stoppers as shown in the illustration.

Text in Illustration





2. INSTALL REAR STABILIZER BAR

(a) Install the rear stabilizer bar and rear No. 1 stabilizer bracket LH and RH to the rear suspension member with the 4 bolts.

Torque : 78 Nm (795 kgf-cm, 58 ft-lbf)

3. INSTALL REAR STABILIZER LINK ASSEMBLY LH

NOTICE:
Since the rear stabilizer link, rear stabilizer cushions and lock nut are not reusable, new parts must be installed.

(a) Temporarily install a new rear stabilizer link and 2 new rear stabilizer cushions to the rear No. 2 suspension arm with 2 new nuts.

(b) Tighten the upper nut.

Torque : 95 Nm (969 kgf-cm, 70 ft-lbf)

HINT
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

(c) Tighten the lower lock nut.

Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)

4. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT
Use the same procedure described for the LH side.

5. INSTALL REAR SUSPENSION MEMBER BRACE LH

(a) Install the rear suspension member brace to the rear suspension member with the 3 bolts.

Torque : 32 Nm (326 kgf-cm, 24 ft-lbf)