Installation

AXLE AND DIFFERENTIAL: REAR AXLE HUB: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH

(a) Install the rear axle hub and bearing assembly with 4 bolts.

Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)

2. CONNECT SKID CONTROL SENSOR WIRE LH

(a) Connect the connector.

3. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

4. INSTALL REAR DISC Installation

5. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

(a) Connect the rear disc brake caliper assembly with the 2 bolts.

Torque : 57 Nm (585 kgf-cm, 42 ft-lbf)

6. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY Removal

7. INSTALL PARKING BRAKE LEVER PROTECTOR

8. INSPECT AND ADJUST PARKING BRAKE

Adjustments

9. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

Installation

10. INSPECT REAR WHEEL ALIGNMENT

Rear Wheel Alignment

11. CHECK FOR SPEED SENSOR SIGNAL Installation