Component Tests and General Diagnostics

TIRE / WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION

1. INSPECT TIRE

(a) Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:





(b) Using a dial indicator, check the runout of the tires.





Maximum tire runout:

1.4 mm (0.0551 in.)

2. ROTATE TIRE

(a) Rotate the tires as shown in the illustration.





Text in Illustration





3. INSPECT WHEEL BALANCE

(a) Check and adjust the off-the-car balance.





Maximum imbalance after adjustment:

8.0 g (0.0176 lb)

NOTICE:
* Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
* Do not touch the sticking surface of the tape.
* Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)

* Push the balance weight securely with your finger to adhere it to the position.
* Do not reuse a balance weight.

HINT
The inner side balance weights should be installed by clipping them to the rim.

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

Front Axle Hub

5. INSPECT REAR AXLE HUB BEARING LOOSENESS

Rear Axle Hub

6. INSPECT FRONT AXLE HUB RUNOUT

Front Axle Hub