Pinout Values and Diagnostic Parameters

SLIDING ROOF: SLIDING ROOF SYSTEM: TERMINALS OF ECU

1. CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)

(a) Disconnect the J3 sliding roof drive gear sub- assembly connector.





(b) Measure the voltage and resistance according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the J3 sliding roof drive gear sub- assembly connector.

(d) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the sliding roof drive gear sub-assembly may have a malfunction.