Installation

2AZ-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL OIL PRESSURE SWITCH

(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.





Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

(b) Using a deep socket wrench 24 mm, install the oil pressure switch.

Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

NOTICE:
Do not start the engine within 1 hour of installation.

(c) Connect the connector.

2. CHECK ENGINE OIL LEVEL

Testing and Inspection

3. INSPECT FOR ENGINE OIL LEAK