Removal

LIGHTING: REAR COMBINATION LIGHT ASSEMBLY: REMOVAL

HINT
* Use the same procedure for both the RH and LH sides.
* The procedure described below is for the LH side.

1. REMOVE REAR COMBINATION LIGHT SERVICE COVER





Text in Illustration





(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 7 claws and remove the rear combination light service cover.

2. REMOVE REAR COMBINATION LIGHT ASSEMBLY





(a) Disconnect the connector.

(b) Remove the 3 nuts.

(c) Slide the rear combination light toward the rear of the vehicle.





Text in Illustration





3. REMOVE REAR COMBINATION LIGHT LENS GASKET





(a) Remove the rear combination light lens gasket.

NOTICE:
* Detach the gasket if it adheres to the body.
* Do not reuse a removed gasket. Replace it with a new one to prevent water from entering.

4. REMOVE TAIL AND STOP LIGHT BULB





(a) Turn the rear combination light socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.

(b) Remove the rear combination light bulb from the light socket.

5. REMOVE REAR TURN SIGNAL LIGHT BULB





(a) Turn the rear turn signal light socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.

(b) Remove the rear turn signal light bulb from the light socket.

6. REMOVE BACK UP LIGHT BULB





(a) Turn the back up light socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.

(b) Remove the back up light bulb from the light socket.

7. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY





(a) Disengage the clamp and remove the rear combination light socket and wire.