Removal

SUSPENSION: FRONT LOWER BALL JOINT: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The procedure listed below is for the LH side.

1. REMOVE FRONT WHEEL

2. REMOVE FRONT AXLE HUB NUT Removal

3. SEPARATE FRONT SPEED SENSOR Removal

4. SEPARATE TIE ROD END SUB-ASSEMBLY Removal

5. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal

6. REMOVE FRONT DISC Removal

7. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY Removal

8. REMOVE FRONT AXLE ASSEMBLY Removal

9. REMOVE FRONT LOWER BALL JOINT ASSEMBLY

(a) Secure the front axle assembly in a vise.

NOTICE:
When using a vise, do not overtighten it.

(b) Remove the cotter pin and nut.

(c) Install SST to the front lower ball joint as shown in the illustration.





SST : 09960-20010

09961-02050

NOTICE:
Check that the clearance measurement between SST and the front axle assembly is 1 mm (0.04 in.).

(d) Using SST, remove the front lower ball joint from the front axle assembly as shown in the illustration.





SST : 09960-20010

09961-02010

09961-02050

NOTICE:
* Install SST so that A and B are parallel.
* Be sure to place the wrench on the part indicated in the illustration.
* Do not damage the front lower ball joint dust cover.