Reassembly

U241E AUTOMATIC TRANSAXLE: OIL PUMP: REASSEMBLY

1. INSTALL FRONT OIL PUMP OIL SEAL

(a) Using SST, install a new oil seal into the pump.





SST : 09350-32014

09351-32140

HINT
The seal end should be flush with the outer edge of the oil pump.

(b) Coat the lip of the oil seal with MP grease.

2. INSTALL FRONT OIL PUMP BODY O-RING

(a) Coat a new O-ring with ATF, and install it onto the oil pump body.





3. INSTALL FRONT OIL PUMP DRIVEN GEAR

(a) Coat the front oil pump driven gear with ATF, and install it into the oil pump body with the marked side facing upward.





4. INSTALL FRONT OIL PUMP DRIVE GEAR

(a) Coat the front oil pump drive gear with ATF, and install it into the oil pump body with the marked side facing upward.





5. INSTALL STATOR SHAFT ASSEMBLY

(a) Set the stator shaft by aligning each bolt hole.





(b) Using a T30 ''Torx'' socket, install the 11 bolts.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

6. INSTALL CLUTCH DRUM OIL SEAL RING





NOTICE:
Do not expand the ring ends excessively.

(a) Install the 2 clutch drum oil seal rings.

7. INSPECT OIL PUMP ASSEMBLY

(a) Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.





NOTICE:
Be careful not to damage the oil seal lip.