Reassembly

E351 MANUAL TRANSAXLE: SHIFT AND SELECT LEVER SHAFT: REASSEMBLY

1. INSTALL CONTROL SHAFT COVER OIL SEAL





(a) Using SST and a hammer, tap in a new control shaft cover oil seal to the control shaft cover.

SST : 09950-60010

09951-00280

SST : 09950-70010

09951-07100

Standard depth:

28 to 29 mm (1.1024 to 1.1417 in.)

2. INSTALL SHIFT AND SELECT LEVER SHAFT DUST BOOT





(a) Install the shift and select lever shaft dust boot to the control shaft cover.

HINT
It is acceptable for the dust boot to be tilted +15° to -15°.

3. INSTALL NO. 1 SELECT SPRING SEAT SHAFT SNAP RING





(a) Using a brass bar and hammer, tap in the shaft snap ring.

4. INSTALL NO. 1 SHIFT LEVER INNER





(a) Coat the No. 1 shift lever inner and shift inter lock plate with MP grease, and install them.

5. INSTALL SHIFT INTER LOCK PLATE COVER





(a) Install the shift inter lock plate cover to the shift inter lock plate.

6. INSTALL NO. 1 SELECT SPRING SEAT





(a) Coat the No. 1 select spring seat with MP grease, and install it.

(b) Install the No. 1 select return compression spring and shift inter lock plate assembly to the shift and select lever shaft.

7. INSTALL NO. 2 SHIFT LEVER INNER





(a) Install the No. 2 shift lever inner and No. 2 select return compression spring to the shift and select lever shaft.

(b) Coat the select spring seat No. 2 with MP grease, and install it to the shift and select lever shaft.

(c) Using a brass bar and hammer, tap in the No. 2 select spring seat shaft snap ring to the shift and select lever shaft.

(d) Hold the shift and select lever shaft in a vise with soft jaws.





(e) Using a 5 mm pin punch and a hammer, install the 2 shaft inner lever slotted pins to the shift and select lever shaft.

Clearance A:

0.7 to 1.7 mm (0.0276 to 0.0669 in.)

Clearance B
- 0.4 to 0.6 mm (-0.0158 to 0.0236 in.)

8. INSTALL NO. 2 SELECTING BELLCRANK BUSH





(a) Coat the bushes with MP grease, and install them to the No. 2 selecting bellcrank.

9. INSTALL NO. 2 SELECTING BELLCRANK DUST COVER





(a) Coat the dust cover with MP grease, and install it to the No. 2 selecting bellcrank.

10. INSTALL SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY





(a) Install the selecting bellcrank support to the No. 2 selecting bellcrank.

(b) Install the No. 2 selecting bellcrank plate washer, wave washer and nut.





Torque : 12 Nm (120 kgf-cm, 9 ft-lbf)

11. INSTALL NO. 1 SELECTING BELLCRANK DUST COVER





(a) Install the dust cover to the No. 2 selecting bellcrank.

12. INSTALL SHIFT AND SELECT LEVER BUSH





(a) Install the bush to the No. 2 selecting bellcrank.