Installation

WINDSHIELD / WINDOWGLASS: POWER WINDOW REGULATOR MOTOR: INSTALLATION

1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Install the rear door window division bar with the 2 bolts and screw.

Torque : 6.2 Nm (63 kgf-cm, 54 in-lbf)

(b) Install the rear door weatherstrip.

6. INSTALL REAR DOOR GLASS RUN Reassembly

7. INSTALL REAR DOOR SERVICE HOLE COVER Reassembly

8. INSTALL REAR DOOR TRIM BRACKET Reassembly

9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

10. INSTALL REAR DOOR INSIDE HANDLE BEZEL Reassembly

11. INSTALL REAR DOOR ARMREST BASE UPPER PANEL Reassembly

12. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Apply MP grease to the sliding and rotating areas of the regulator motor.

(b) Using "TORX" socket wrench T25, install the power window regulator motor assembly front with the 3 screws.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

13. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY Reassembly

14. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY Reassembly

15. INSTALL FRONT DOOR SERVICE HOLE COVER Reassembly

16. INSTALL FRONT DOOR TRIM BRACKET Reassembly

17. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

18. INSTALL FRONT DOOR INSIDE HANDLE BEZEL Reassembly

19. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH Reassembly

20. INSTALL FRONT ARMREST BASE UPPER PANEL Reassembly

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)