Trunk / Liftgate: Adjustments

ENGINE HOOD / DOOR: BACK DOOR: ADJUSTMENT





HINT
* Centering bolts are used to mount the door hinge onto the vehicle body and door. The door cannot be adjusted with the centering bolts in. Substitute standard bolts (with washers) for the centering bolts when making adjustments.
* For bolts without torque specifications, check the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSPECT BACK DOOR

(a) Check that the clearance measurements are within the standard ranges.





Standard:





2. REMOVE DECK BOARD ASSEMBLY Removal

3. REMOVE REAR DECK TRIM COVER Removal

4. ADJUST BACK DOOR





(a) Adjust the door position.

(1) Horizontally and vertically adjust the door by loosening the door side hinge bolts.

Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)

(b) Adjust the striker position.





(1) Adjust the striker position by slightly loosening the striker mounting bolts and hitting the striker with a plastic hammer.

(2) Tighten the striker mounting bolts after the adjustment.

Torque : 12 Nm (117 kgf-cm, 8 ft-lbf)

5. INSTALL REAR DECK TRIM COVER Installation

6. INSTALL DECK BOARD ASSEMBLY Installation