Parking Brake System: Adjustments

PARKING BRAKE: PARKING BRAKE SYSTEM: ADJUSTMENT

1. ADJUST REAR DRUM BRAKE SHOE CLEARANCE Installation

2. INSPECT PARKING BRAKE LEVER TRAVEL

(a) Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

Parking brake lever travel:

6 to 9 clicks at 200 N (20 kgf, 45 lbf)

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal

4. REMOVE UPPER CONSOLE PANEL Removal

5. REMOVE REAR CONSOLE BOX COVER Removal

6. REMOVE CONSOLE BOX CARPET Removal

7. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY Removal

8. ADJUST PARKING BRAKE LEVER TRAVEL

(a) Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.





Parking brake lever travel:

6 to 9 clicks at 200 N (20 kgf 45 lbf)

(b) Tighten the lock nut.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(c) Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

(d) Check whether the parking brake drags or not.

(e) When operating the parking brake lever, check that the brake warning light illuminates.

OK:

Brake warning light always illuminates at the first click.

9. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY Installation

10. INSTALL CONSOLE BOX CARPET Installation

11. INSTALL REAR CONSOLE BOX COVER Installation

12. INSTALL UPPER CONSOLE PANEL Installation

13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation