Installation
SUSPENSION: FRONT STABILIZER BAR: INSTALLATION
1. INSTALL FRONT STABILIZER BAR NO. 1 BUSH
(a) Install the stabilizer bar bush onto the stabilizer bar.
HINT
* Install the bush onto the stabilizer so that the bush stopper of the stabilizer bar faces the outside of the vehicle.
* Install the bush with its cutout facing the front of the vehicle.
2. INSTALL FRONT STABILIZER BAR
(a) Install the stabilizer onto the crossmember with the paint mark on the left side of the vehicle.
3. INSTALL FRONT STABILIZER NO. 1 BRACKET LH
(a) Provisionally tighten bolt A.
(b) Tighten the bolts to the specified torque, in the order of B then A.
Torque : 47 Nm (479 kgf-cm, 35 ft-lbf)
4. INSTALL FRONT STABILIZER NO. 1 BRACKET RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
5. INSTALL POWER STEERING GEAR Installation
6. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Installation
7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the stabilizer link with the 2 nuts.
Torque : 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT
If the ball joint turns together with the nut, use a socket hexagon wrench 6 to hold the stud.
8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
9. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH Installation
10. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
11. INSTALL TIE ROD END SUB-ASSEMBLY LH Installation
12. INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
13. INSTALL STEERING COLUMN NO. 1 HOLE COVER SUB-ASSEMBLY Installation
14. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY Installation
15. INSTALL COLUMN HOLE COVER SILENCER SHEET Installation
16. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
17. POSITION WHEELS FACING STRAIGHT AHEAD
18. INSTALL OUTER COWL TOP PANEL Installation
19. INSTALL FRONT AIR SHUTTER SEAL RH Installation
20. INSTALL FRONT WIPER MOTOR AND LINK Installation
21. INSTALL COWL TOP VENTILATOR LOUVER LH Installation
22. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
23. INSTALL HOOD TO COWL TOP SEAL Installation
24. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
25. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
26. INSTALL FRONT WIPER ARM HEAD CAP Installation
27. INSPECT HOOD SUB-ASSEMBLY Adjustments
28. ADJUST HOOD SUB-ASSEMBLY Adjustments
29. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Front Wheel Alignment