Installation

WINDSHIELD / WINDOW GLASS: POWER WINDOW REGULATOR MOTOR: INSTALLATION

1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Install the rear door window division bar with the 2 bolts and screw.

Torque : 6.2 Nm (63 kgf-cm, 54 in-lbf)

(b) Install the rear door weatherstrip.

5. INSTALL REAR DOOR GLASS RUN Reassembly

6. INSTALL REAR DOOR SERVICE HOLE COVER Reassembly

7. INSTALL REAR DOOR TRIM BRACKET Reassembly

8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

9. INSTALL REAR DOOR INSIDE HANDLE BEZEL Reassembly

10. INSTALL REAR DOOR ARMREST BASE UPPER PANEL Reassembly

11. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Apply MP grease to the sliding and rotating areas of the regulator motor.

(b) Using "TORX" socket wrench T25, install the front power window regulator motor assembly with the 3 screws.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

12. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY Reassembly

13. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY Reassembly

14. INSTALL FRONT DOOR SERVICE HOLE COVER Reassembly

15. INSTALL FRONT DOOR TRIM BRACKET Reassembly

16. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

17. INSTALL FRONT DOOR INSIDE HANDLE BEZEL Reassembly

18. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH Reassembly

19. INSTALL FRONT ARMREST BASE UPPER PANEL Reassembly

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)