Service Manual - Correction

NUMBER 02-42-85

APPLICABILITY DATE 06-03-85
1985 4-DOOR SEDAN AND STATION WAGON VEHICLES


SUBJECT: 1985 SERVICE MANUAL CORRECTIONS

On Page 11, Section 2-6, of the 1985 Service Manual, the Maintenance Standard Chart reads "Clearance "H" between float and upper mating surface on float chamber when front seat comes in contact with valve stem". The tolerance for this measurement reads 18.0 - 18.4 mm (0.709 - 0.724 in.). The correct tolerance for this measurement should read, 11.5 - 12.5 mm (0.453 - 0.492 in.).

The Maintenance Standard Chart also reads "Clearance "L" between valve stem and float seat when float is fully lowered". The tolerance for this measurement reads 1.3 - 1.7 mm (0.51 - 0.67 in.). The correct tolerance for this measurement should read, 1.5 - 1.9 mm (0.059 - 0.075 in.).

FIGURE 1 - INCORRECT:

FIGURE 2 - CORRECT:

The illustrations below show the correct and incorrect chart applications.