Hitachi

Fig. 2 Exploded view of Hitachi breakerless type distributor.:

1. Remove cap and rotor, Fig. 2.
2. Remove vacuum controller retaining screws and controller assembly.
3. Disconnect wire with rubber seal from electronic control unit.
4. Drive pinion gear retaining pin out with suitable drift and hammer.
5. Remove pinion gear and thrust washers.
6. Remove pickup coil base retaining screws.
7. Remove pickup coil base, distributor shaft, and governor assembly.
8. Remove dust-proof packing from top of shaft.
9. Remove screw inside top of shaft.
10. Remove shaft and governor assembly.
11. Mark each part of governor assembly before disassembly to facilitate installation.
12. Reverse procedure to assemble.